Polycom DOC2238A Manuel d'utilisateur télécharger pdf (Page 48)

Chapter 2 - Hardware Installation

2-28

Mounting the MGC+50 on a Rack

The MGC+50 can be mounted in a 19” rack using two mounting plates (Kit

2012A). The side plates are usually mounted when shipped, but if not, follow

the directions below to install the mounted plates on the MGC+50 and then

mount the MGC+50 on the 19” rack.

To install and mount the MGC+50:

1. Make sure that the MGC+50 power is turned OFF and it is disconnected

from the AC power.

2. Remove the five nylon plug hole covers from the MGC+50 protective

side covers (using a slotted screwdriver).

3. Using an Allen wrench (M4), remove the five screws from the MGC+50

side covers.

4. Remove the MGC+50 side covers from both sides.

5. To remove the plate from both MGC+50 sides, the side screws have to be

removed. To remove the screws from the left side of the MGC+, the

Control Board, Server panel, Functional modules and power supply must

be removed first. These procedures are described in Chapter 5 of this

manual. For detailed procedures, see Chapter 5, “Replacing the Main

Control Module” on page 5-17. For instructions on how to remove the

power supply, see Chapter 5, “Replacing the Power Supply Module on

the MGC+50” on page 5-11.

front

remove

side cover

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 159 160

Pas de commentaire

Polycom DOC2238A Manuel d'utilisateur Page 48