Polycom DOC2238A Manuel d'utilisateur télécharger pdf (Page 146)

Chapter 5 - System Maintenance

5-14

9. Slide in the replacement Power Supply Module from the front panel and

push it firmly into its place.

10. Tighten the six screws on the front panel of the MGC+50 that secure the

Power Supply Module.

11. Connect the red power cable to the +5V screw and ensure that the nut is

well fastened and secured:

— First install the flat washer.

— Next, install the terminal ring of the power cable.

— Next, install the second flat washer.

— Then, install the spring washer.

— Last, screw the nut.

12. Connect the black power cable to the -5V screw in the order described in

step 11 and ensure that the nut is well fastened and secured.

13. Reconnect the AC input (J1) and the 12V/5V Sense connectors (J2).

14. Reposition the fans cover panel on the rear panel. Ensure that the two fan

connectors are in their place and tighten the six screws to secure the fan

cover to its place.

15. Connect the AC power cable to the MCU and turn on the MCU.

The green Power Supply Module LED should be green to indicate that

the MCU power is on.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 159 160

Pas de commentaire

Polycom DOC2238A Manuel d'utilisateur Page 146