Polycom DOC2231A Manuel d'utilisateur télécharger pdf (Page 24)

Chapter 2 - Hardware Installation

2-12

To connect the MGC+ to the ISDN network or T1-CAS Network:

• Connect the 8-pin RJ-45 connector of the network cable to the NET

RJ-45 jack on the rear panel of the MGC+. Repeat this step for each of

the ISDN network lines to be connected to the Network Interface card

installed in the MCU.

Figure 2-5: ISDN network connection

Leased lines should be connected using an adapter with a screw

connector with solid conductor wires or a similar adapter.

• Connect one side of the adapter to the NET RJ-45 jack on the rear panel

of the MGC+. Then connect the leased line wires to the other side of the

adapter.

ISDN network

connection

ISDN Network connection

for 4 spans

ISDN Network connection

for 8 s

ans

The ISDN and T1-CAS network properties must be defined in the Network

Services. For details, see the MGC+ Administrator’s Guide, Chapter 3.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Pas de commentaire

Polycom DOC2231A Manuel d'utilisateur Page 24