Polycom DOC2238A Manuel d'utilisateur télécharger pdf (Page 52)

Chapter 2 - Hardware Installation

2-32

Connecting and Setting Up the MGC+50

Use the MGC+50 rear panel diagram below for reference.

Figure 2-14: MGC+50 Rear Panel with External Connectors

To connect the MGC+50 to the network and power source and set up the

system the following procedures are performed:

• Connecting the MGC+ unit to the power source (AC inlet)

• Connecting the MGC+ unit to the LAN Network (C.B., I/O)

• Connecting the MGC+ unit to the Operator Workstation (PC) directly via

COM2 (optional)

• Connecting the MGC+ unit to the network(s)

MGC+50 Dongle

MGC+50 is shipped with a serial dongle and is installed on COM1 of the

Control unit’s rear I/O panel. A special bracket ensures that the dongle

remains in its fixed position. The dongle is required for normal operation of

the MCU. If the dongle is missing, please contact support.

DEBUG

LINE IN

COM2

COM1

KEYBOARD

MOUSE

VGA

LAN

COM2

COM1

KEYBOARD

MOUSE

VGA

LAN

ALARMS

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 159 160

Commentaires sur ces manuels

Pas de commentaire