Polycom DOC2230A Manuel d'utilisateur télécharger pdf (Page 39)

Chapter 3 - Initial System Configuration

3-15

The Spans and Phones dialog box opens.

This dialog box is used to assign circuit identification numbers and the

dial-in phone number ranges to be used in dial-in conferences. Circuit

orders are automatically assigned to spans. If only one service provider is

used, define all the PRI lines here.

The dial-in phone numbers are allocated to the MCU by the service

provider (carrier) and should be obtained from the service provider.

To define

a span

To define a dial-in phone

numbers range

To delete a

currently

defined dial-in

numbers range

To allocate

dial-in numbers

for Gateway

calls

To delete

allocated dial-in

numbers for

Gateway calls

The number used

to identify the

MCU

To remove a

span

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 143 144

Pas de commentaire

Polycom DOC2230A Manuel d'utilisateur Page 39