Polycom DOC2237A Manuel d'utilisateur télécharger pdf (Page 22)

Chapter 2 - Hardware Installation

2-2

MGC-100 Hardware Installation

Unpacking and Positioning the MGC-100

To unpack and position the MGC-100:

1. When you receive your MGC-100, inspect the equipment for damage

and verify that the components match the packing slip. If you did not

receive a component or if there is damage to the system, notify your

service representative immediately.

Figure 2-1: MGC-100 package

2. Place the MGC-100 unit on a stable flat surface in a location that meets

the MGC environment requirements, which are:

• Operating temperature: 10°–40°C (50°–104°F)

• Humidity: 15%–90% non-condensing

• Altitude: Up to 3,000m (10,000ft)

• ESD: +8 kV

Carrying Strap

Lock in Open Position

Wood Packing Case

Lock in Closed Position

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 169 170

Pas de commentaire

Polycom DOC2237A Manuel d'utilisateur Page 22